Velocity Increase In New Gun Barrels

Written by Sierra Bullets New Product Development Manager Mark Walker

In a previous post, I discussed a couple of methods to tune a load to your barrel to help achieve the best accuracy possible. People most often work on load tuning if they get a new rifle or have a different barrel installed. In both instances, the barrel is new and has not been fired very much. According to most competitive shooters, this is the most accurate your barrel will ever be, so getting it tuned and shooting accurately is a priority.

Even though after you work up a load and your new barrel is shooting great, a lot of shooters notice that at around 100 to 150 rounds their rifle may stop shooting as accurately. I had this happen to a rifle and I was confused as to why something that worked so well to begin with would all of a sudden quit shooting. I decided to break out the chronograph to do another load work up to see what was going on. To my surprise, the velocity had increased around 80 fps over the original velocity! After performing another ladder test and adjusting the seating depth, the rifle was once again shooting well.

There are several thoughts on why this may happen, however, you can rest assured that it does happen. One thought is that as the barrel breaks in, the tooling marks in the throat of the chamber smooth out and allow less resistance to the bullet as it exits the bore thereby increasing speed. Another idea is that the throat area starts to get a little rough which in turn causes more resistance which increases pressure and therefore more velocity. I’m sure there are some out there who have a better understanding as to why this happens, but it can definitely affect the accuracy of your rifle. So be aware and never be afraid to rework a load to keep your rifle in tune.

This entry was posted in Competitive Shooting and tagged , , , , , , , , . Bookmark the permalink.

9 Responses to Velocity Increase In New Gun Barrels

  1. firstriverbend says:

    Sounds like time for a good bore scope to be employed. 🙂


  2. Brittius says:

    Reblogged this on .


  3. Jim See says:

    Seen it too many times to count. All my match barrels get a “generic round” loaded for them, which has worked well in barrels historically. After I hit 150 rounds I fine tune the load and never look back, until the tube starts to slow down at it’s life end.


    • Rickey Cook says:

      have you used the eldx 208grain for 30.06 and 308? if so can you tell me any cautions not posted because i cant find much


  4. Speedy Gonzalez says:

    Alex Lipworth and I documented this phenomena about four years ago and I have told all my customer’s and shooters about this.
    My son Mikee would shoot 100 roinds through all new barrels we planned on shooting before we would begin to do load development. We had a shooting snail that caught all the bullets set up in front of an indoor bench. We called it a wear in process because upon careful examination of the bore when the “Speed Up” takes place the cut rifled bore resembles that more of a button rifled barrels with the lands taking on more the softer look of a buttoned bore.
    Good luck and good shooting,
    Speedy Gonzalez


  5. Jerry says:

    would this same phenomena apply to re-chambered barrels?


  6. Eric Rumpel says:

    Use David Tubbs’ treated bullets, save time & money with WAY better results!!


  7. Kevin T says:

    I finally have a good use for that cheap steel cased ammo!!
    Didn’t people use to put lapping compound on bullets to achieve something like this?


Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s